68 FR 196 pgs. 58285-58287 - Airworthiness Directives; Dassault Model Falcon 900EX Series Airplanes
Type: PRORULEVolume: 68Number: 196Pages: 58285 - 58287
Docket number: [Docket No. 2001-NM-283-AD]
FR document: [FR Doc. 03-25589 Filed 10-8-03; 8:45 am]
Agency: Transportation Department
Sub Agency: Federal Aviation Administration
Official PDF Version: PDF Version
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 2001-NM-283-AD]
Airworthiness Directives; Dassault Model Falcon 900EX Series Airplanes
Federal Aviation Administration, DOT.
Notice of proposed rulemaking (NPRM).
This document proposes the adoption of a new airworthiness directive (AD) that is applicable to certain Dassault Model Falcon 900EX series airplanes. This proposal would require modification of the front attachment area of the No. 2 engine. This action is necessary to prevent failure of the fail-safe lugs of the hoisting plate of the forward engine mount, and subsequent cracking of the pick-up folded sheet of the pylon forward rib. Such cracking could rupture the mast case box, which could result in loss of the two forward engine mounts and consequent separation of the engine from the airplane. This action is intended to address the identified unsafe condition.
Comments must be received by November 10, 2003.
Submit comments in triplicate to the Federal Aviation Administration (FAA), Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 2001-NM-283-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056. Comments may be inspected at this location between 9 a.m. and 3 p.m., Monday through Friday, except Federal holidays. Comments may be submitted via fax to (425) 227-1232. Comments may also be sent via the Internet using the following address: firstname.lastname@example.org. Comments sent via fax or the Internet must contain "Docket No. 2001-NM-283-AD" in the subject line and need not be submitted in triplicate. Comments sent via the Internet as attached electronic files must be formatted in Microsoft Word 97 or 2000 or ASCII text.
The service information referenced in the proposed rule may be obtained from Dassault Falcon Jet, P.O. Box 2000, South Hackensack, New Jersey 07606. This information may be examined at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington.
FOR FURTHER INFORMATION CONTACT:
Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 227-1137; fax (425) 227-1149.
Interested persons are invited to participate in the making of the proposed rule by submitting such written data, views, or arguments as they may desire. Communications shall identify the Rules Docket number and be submitted in triplicate to the address specified above. All communications received on or before the closing date for comments, specified above, will be considered before taking action on the proposed rule. The proposals contained in this action may be changed in light of the comments received.
Submit comments using the following format:
• Organize comments issue-by-issue. For example, discuss a request to change the compliance time and a request to change the service bulletin reference as two separate issues.
• For each issue, state what specific change to the proposed AD is being requested.
• Include justification ( e.g. , reasons or data) for each request.
Comments are specifically invited on the overall regulatory, economic, environmental, and energy aspects of the proposed rule. All comments submitted will be available, both before and after the closing date for comments, in the Rules Docket for examination by interested persons. A report summarizing each FAA-public contact concerned with the substance of this proposal will be filed in the Rules Docket.
Commenters wishing the FAA to acknowledge receipt of their comments submitted in response to this action must submit a self-addressed, stamped postcard on which the following statement is made: "Comments to Docket Number 2001-NM-283-AD." The postcard will be date stamped and returned to the commenter.
Availability of NPRMs
Any person may obtain a copy of this NPRM by submitting a request to the FAA, Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 2001-NM-283-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056.
The Direction Generale de l'Aviation Civile (DGAC), which is the airworthiness authority for France, notified the FAA that an unsafe condition may exist on certain Dassault Model Falcon 900EX series airplanes. The DGAC advises that fatigue tests revealed that the fail-safe lugs of the forward engine mount may not have adequate fatigue strength. Failure of the lugs could result in cracking of the pick-up folded sheet of the pylon forward rib, and consequent rupture of the mast case box. Such conditions, if not corrected, could result in loss of the two forward engine mounts and consequent separation of the engine from the airplane.
Explanation of Relevant Service Information
Dassault has issued Service Bulletin F900EX-103, dated May 23, 2001, which describes procedures for modification of the No. 2 engine front attachment area. The modification involves replacing the No. 2 engine hoisting shield with a reinforced shield at the safety device attachments, and replacing the front attachment pickup doublers with new, thicker doublers. Accomplishment of the actions specified in the service bulletin is intended to adequately address the identified unsafe condition. The DGAC classified this service bulletin as mandatory and issued French airworthiness directive 2001-160-027(B), dated May 2, 2001, to ensure the continued airworthiness of these airplanes in France.
This airplane model is manufactured in France and is type certificated for operation in the United States under the provisions of section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and the applicable bilateral airworthiness agreement. Pursuant to this bilateral airworthiness agreement, the DGAC has kept us informed of the situation described above. We have examined the findings of the DGAC, reviewed all available information, and determined that AD action is necessary for products of this type design that are certificated for operation in the United States.
Explanation of Requirements of Proposed AD
Since an unsafe condition has been identified that is likely to exist or develop on other airplanes of the same type design registered in the United States, the proposed AD would require accomplishment of the actions specified in the service bulletin described previously, except as discussed below.
Difference Between Proposed AD and French Airworthiness Directive
The French airworthiness directive specifies a compliance time of "Before 3,750 flights since new," for accomplishment of the modification of the front attachment area of the No. 2 engine. However, this proposed AD would require a compliance time of "Prior to the accumulation of 3,750 flight cycles since the date of issuance of the original Airworthiness Certificate or the date of issuance of the Export Certificate of Airworthiness, whichever occurs first." This decision is based on our determination that "since new" may be interpreted differently by different operators. We find that our proposed terminology is generally understood within the industry, and records will always exist that establish these dates with certainty.
We estimate that 36 airplanes of U.S. registry would be affected by this proposed AD, that it would take about 85 work hours per airplane to accomplish the proposed modification, and that the average labor rate is $65 per work hour. Required parts would cost about $14,479 per airplane. Based on these figures, the cost impact of the proposed modification on U.S. operators is estimated to be $720,144, or $20,004 per airplane.
The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the proposed requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.
The regulations proposed herein would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this proposal would not have federalism implications under Executive Order 13132.
For the reasons discussed above, I certify that this proposed regulation (1) is not a "significant regulatory action" under Executive Order 12866; (2) is not a "significant rule" under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) if promulgated, will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A copy of the draft regulatory evaluation prepared for this action is contained in the Rules Docket. A copy of it may be obtained by contacting the Rules Docket at the location provided under the caption ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.
The Proposed Amendment
Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration proposes to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39-AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
49 U.S.C. 106(g), 40113, 44701.
§ 39.13 [Amended]
2. Section 39.13 is amended by adding the following new airworthiness directive:
Dassault Aviation: Docket 2001-NM-283-AD.
Applicability: Model Falcon 900EX series airplanes, serial numbers 1 through 60 inclusive; certificated in any category; except those on which Dassault Modifications M2754 and M2925, identified in Dassault Service Bulletin F900EX-103, dated May 23, 2001, have been accomplished.
Compliance: Required as indicated, unless accomplished previously.
To prevent failure of the fail-safe lugs of the forward engine mount, and consequent cracking of the pick-up folded sheet of the pylon forward rib, which could rupture the mast case box and result in loss of the two forward engine mounts and consequent separation of the engine from the airplane, accomplish the following:
(a) Prior to the accumulation of 3,750 flight cycles since the date of issuance of the original Airworthiness Certificate or the date of issuance of the Export Certificate of Airworthiness, whichever occurs first: Modify the front attachment area of the No. 2 engine by doing all the actions per Paragraphs 2.A. through 2.D. of the Accomplishment Instructions of Dassault Service Bulletin F900EX-103, dated May 23, 2001.
Alternative Methods of Compliance
(b) In accordance with 14 CFR 39.19, the Manager, International Branch, ANM-116, FAA, Transport Airplane Directorate, is authorized to approve alternative methods of compliance for this AD.
The subject of this AD is addressed in French airworthiness directive 2001-160-027(B), dated May 2, 2001.
Issued in Renton, Washington, on October 3, 2003.
Kalene C. Yanamura,
Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. 03-25589 Filed 10-8-03; 8:45 am]
BILLING CODE 4910-13-P