90 FR 65 pgs. 14924-14927 - Airworthiness Directives; Dassault Aviation Airplanes
Type: PRORULEVolume: 90Number: 65Pages: 14924 - 14927
Pages: 14924, 14925, 14926, 14927Docket number: [Docket No. FAA-2025-0484; Project Identifier MCAI-2024-00690-T]
FR document: [FR Doc. 2025-05862 Filed 4-4-25; 8:45 am]
Agency: Transportation Department
Sub Agency: Federal Aviation Administration
Official PDF Version: PDF Version
[top]
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. FAA-2025-0484; Project Identifier MCAI-2024-00690-T]
RIN 2120-AA64
Airworthiness Directives; Dassault Aviation Airplanes
AGENCY:
Federal Aviation Administration (FAA), DOT.
ACTION:
Notice of proposed rulemaking (NPRM).
SUMMARY:
[top] The FAA proposes to adopt a new airworthiness directive (AD) for all Dassault Aviation Model FALCON 7X airplanes. This proposed AD was prompted by hydraulic leakage from the spoiler power control unit (SPPCU) in service. Relevant investigations determined that, following certain failures, the spoiler electrical control unit (SPECU) can deliver an untimely and permanent activation command to the SPPCU standby electrical pump, which can possibly result in overheating and significant hydraulic leakage of the unit. This proposed AD would require replacement of affected SPECUs, and would prohibit the installation of affected parts, as specified in a European Union Aviation Safety Agency
DATES:
The FAA must receive comments on this proposed AD by May 22, 2025.
ADDRESSES:
You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:
• Federal eRulemaking Portal: Go to regulations.gov. Follow the instructions for submitting comments.
• Fax: 202-493-2251.
• Fax: 202-493-2251.
• Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590.
• Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
AD Docket: You may examine the AD docket at regulations.gov under Docket No. FAA-2025-0484; or in person at Docket Operations between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this NPRM, the mandatory continuing airworthiness information (MCAI), any comments received, and other information. The street address for Docket Operations is listed above.
Material Incorporated by Reference:
• For EASA material identified in this proposed AD, contact EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; telephone +49 221 8999 000; email ADs@easa.europa.eu; website easa.europa.eu. You may find this material on the EASA website at ad.easa.europa.eu. It is also available at regulations.gov under Docket No. FAA-2025-0484.
• You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195.
FOR FURTHER INFORMATION CONTACT:
William Reisenauer, Aviation Safety Engineer, FAA, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; phone: 516-228-7301; email: william.e.reisenauer@faa.gov.
SUPPLEMENTARY INFORMATION:
Comments Invited
The FAA invites you to send any written relevant data, views, or arguments about this proposal. Send your comments to an address listed under the ADDRESSES section. Include "Docket No. FAA-2025-0484; Project Identifier MCAI-2024-00690-T" at the beginning of your comments. The most helpful comments reference a specific portion of the proposal, explain the reason for any recommended change, and include supporting data. The FAA will consider all comments received by the closing date and may amend this proposal because of those comments.
Except for Confidential Business Information (CBI) as described in the following paragraph, and other information as described in 14 CFR 11.35, the FAA will post all comments received, without change, to regulations.gov, including any personal information you provide. The agency will also post a report summarizing each substantive verbal contact received about this NPRM.
Confidential Business Information
CBI is commercial or financial information that is both customarily and actually treated as private by its owner. Under the Freedom of Information Act (FOIA) (5 U.S.C. 552), CBI is exempt from public disclosure. If your comments responsive to this NPRM contain commercial or financial information that is customarily treated as private, that you actually treat as private, and that is relevant or responsive to this NPRM, it is important that you clearly designate the submitted comments as CBI. Please mark each page of your submission containing CBI as "PROPIN." The FAA will treat such marked submissions as confidential under the FOIA, and they will not be placed in the public docket of this NPRM. Submissions containing CBI should be sent to William Reisenauer, Aviation Safety Engineer, FAA, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; phone: 516-228-7301; email: william.e.reisenauer@faa.gov. Any commentary that the FAA receives that is not specifically designated as CBI will be placed in the public docket for this rulemaking.
Background
EASA, which is the Technical Agent for the Member States of the European Union, has issued EASA AD 2024-0224, dated November 26, 2024 (EASA AD 2024-0224) (also referred to as the MCAI), to correct an unsafe condition for all Dassault Aviation Model FALCON 7X airplanes. The MCAI states hydraulic leakage from the SPPCU led to investigations that determined that following certain failures, the SPECU can deliver an untimely and permanent activation command to the SPPCU standby electrical pump, which can result in overheating and significant hydraulic leakage of the unit. This condition, if not corrected, could lead to further occurrences of equipment overheating and hydraulic leakage in the fuel equipment bay, which, during ground operations, could cause uncontrolled fire in that area.
You may examine the MCAI in the AD docket at regulations.gov under Docket No. FAA-2025-0484.
Material Incorporated by Reference Under 1 CFR Part 51
EASA AD 2024-0224 specifies procedures for replacement of affected SPECUs, including an inspection of the SPPCU for overheating and hydraulic leak marks and repair. EASA AD 2024-0224 also prohibits the installation of affected parts. This material is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.
FAA's Determination
This product has been approved by the aviation authority of another country and is approved for operation in the United States. Pursuant to the FAA's bilateral agreement with this State of Design Authority, it has notified the FAA of the unsafe condition described in the MCAI referenced above. The FAA is issuing this NPRM after determining that the unsafe condition described previously is likely to exist or develop in other products of the same type design.
Proposed AD Requirements in This NPRM
This proposed AD would require accomplishing the actions specified in EASA AD 2024-0224 described previously, except for any differences identified as exceptions in the regulatory text of this proposed AD.
Explanation of Required Compliance Information
[top] In the FAA's ongoing efforts to improve the efficiency of the AD process, the FAA developed a process to use some civil aviation authority (CAA) ADs as the primary source of information for compliance with requirements for corresponding FAA ADs. The FAA has been coordinating this process with manufacturers and CAAs. As a result, the FAA proposes to incorporate EASA AD 2024-0224 by reference in the FAA final rule. This proposed AD would, therefore, require compliance with EASA AD 2024-0224 in its entirety through that incorporation, except for any differences identified as exceptions in the regulatory text of this proposed AD. Using common terms that are the same as the heading of a particular section in
Costs of Compliance
The FAA estimates that this AD, if adopted as proposed, would affect 160 airplanes of U.S. registry. The FAA estimates the following costs to comply with this proposed AD:
| Labor cost | Parts cost | Cost per product | Cost on U.S. operators |
|---|---|---|---|
| 1 work-hour × $85 per hour = $85 | $22,597 | $22,682 | Up to $3,629,120. |
The FAA has included all known costs in its cost estimate. According to the manufacturer, however, some or all of the costs of this proposed AD may be covered under warranty, thereby reducing the cost impact on affected operators.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.
The FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: General requirements. Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
The FAA determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
(1) Is not a "significant regulatory action" under Executive Order 12866,
(2) Would not affect intrastate aviation in Alaska, and
(3) Would not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39-AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority:
49 U.S.C. 106(g), 40113, 44701.
§?39.13 [Amended]
2. The FAA amends §?39.13 by adding the following new airworthiness directive:
Dassault Aviation: Docket No. FAA-2025-0484; Project Identifier MCAI-2024-00690-T.
(a) Comments Due Date
The FAA must receive comments on this airworthiness directive (AD) by May 22, 2025.
(b) Affected ADs
None.
(c) Applicability
This AD applies to all Dassault Aviation Model FALCON 7X airplanes, certificated in any category.
(d) Subject
Air Transport Association (ATA) of America Code 27, Flight Controls.
(e) Unsafe Condition
This AD was prompted by hydraulic leakage from the spoiler power control unit (SPPCU) in service. Relevant investigations determined that, following certain failures, the spoiler electrical control unit (SPECU) can deliver an untimely and permanent activation command to the SPPCU standby electrical pump, which can possibly result in overheating and significant hydraulic leakage of the unit. This condition, if not corrected, could lead to further occurrences of equipment overheating and hydraulic leakage in the fuel equipment bay during ground operations, which could cause uncontrolled fire in that area.
(f) Compliance
Comply with this AD within the compliance times specified, unless already done.
(g) Requirements
Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA AD 2024-0224.
(h) Exceptions to EASA AD 2024-0224
(1) Where EASA AD 2024-0224 refers to its effective date, this AD requires using the effective date of this AD.
(2) This AD does not adopt the "Remarks" section of EASA AD 2024-0224.
(i) Additional AD Provisions
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the manager of the International Validation Branch, send it to the attention of the person identified in paragraph (j) of this AD and email to: AMOC@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, International Validation Branch, FAA; or EASA; or Dassault Aviation's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature.
(j) Additional Information
[top] For more information about this AD, contact William Reisenauer, Aviation Safety Engineer, FAA, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; phone: 516-228-7301; email: william.e.reisenauer@faa.gov.
(k) Material Incorporated by Reference
(1) The Director of the Federal Register approved the incorporation by reference of the material listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.
(2) You must use this material as applicable to do the actions required by this AD, unless this AD specifies otherwise.
(i) European Union Aviation Safety Agency (EASA) AD 2024-0224, dated November 26, 2024.
(ii) Reserved.
(3) For EASA material identified in this AD, contact EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; telephone +49 221 8999 000; email ADs@easa.europa.eu; website easa.europa.eu. You may find this material on the EASA website at ad.easa.europa.eu.
(4) You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195.
(5) You may view this material at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, visit www.archives.gov/federal-register/cfr/ibr-locations or email fr.inspection@nara.gov.
Issued on April 1, 2025.
Steven W. Thompson,
Acting Deputy Director, Compliance & Airworthiness Division, Aircraft Certification Service.
[FR Doc. 2025-05862 Filed 4-4-25; 8:45 am]
BILLING CODE 4910-13-P