89 FR 162 pgs. 67523-67525 - Airworthiness Directives; MHI RJ Aviation ULC (Type Certificate Previously Held by Bombardier, Inc.) Airplanes
Type: RULEVolume: 89Number: 162Pages: 67523 - 67525
Pages: 67523, 67524, 67525Docket number: [Docket No. FAA-2024-1009; Project Identifier MCAI-2023-01221-T; Amendment 39-22782; AD 2024-14-01]
FR document: [FR Doc. 2024-18629 Filed 8-20-24; 8:45 am]
Agency: Transportation Department
Sub Agency: Federal Aviation Administration
Official PDF Version: PDF Version
[top]
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. FAA-2024-1009; Project Identifier MCAI-2023-01221-T; Amendment 39-22782; AD 2024-14-01]
RIN 2120-AA64
Airworthiness Directives; MHI RJ Aviation ULC (Type Certificate Previously Held by Bombardier, Inc.) Airplanes
AGENCY:
Federal Aviation Administration (FAA), DOT.
ACTION:
Final rule.
SUMMARY:
The FAA is adopting a new airworthiness directive (AD) for certain MHI RJ Aviation ULC Model CL-600-2D15 (Regional Jet Series 705) and CL-600-2D24 (Regional Jet Series 900) airplanes. This AD was prompted by a report that torque wrenches used during production installation of bulkhead fittings on the oxygen lines of the flightcrew oxygen mask stowage boxes and adapter fitting on the oxygen pressure gauge were out of calibration, which resulted in a higher torque level setting than required. This AD requires replacement of the affected oxygen line fittings, as specified in a Transport Canada AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
DATES:
This AD is effective September 25, 2024.
The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of September 25, 2024.
ADDRESSES:
AD Docket: You may examine the AD docket at regulations.gov under Docket No. FAA-2024-1009; or in person at Docket Operations between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this final rule, the mandatory continuing airworthiness information (MCAI), any comments received, and other information. The address for Docket Operations is U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590.
Material Incorporated by Reference:
[top] • For Transport Canada material, contact Transport Canada, Transport Canada National Aircraft Certification, 159 Cleopatra Drive, Nepean, Ontario K1A 0N5, Canada; telephone 888-663-3639; email TC.AirworthinessDirectives-
• You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195.
FOR FURTHER INFORMATION CONTACT:
Fatin Saumik, Aviation Safety Engineer, FAA, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 516-228-7300; email Fatin.R.Saumik@faa.gov.
SUPPLEMENTARY INFORMATION:
Background
The FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to certain MHI RJ Aviation ULC Model CL-600-2D15 (Regional Jet Series 705) and CL-600-2D24 (Regional Jet Series 900) airplanes. The NPRM published in the Federal Register on April 29, 2024 (89 FR 33297). The NPRM was prompted by AD CF-2023-75, dated November 28, 2023, issued by Transport Canada, which is the aviation authority for Canada (Transport Canada AD CF-2023-75) (also referred to as the MCAI). The MCAI states MHI RJ Aviation ULC received a quality escape notice from a supplier, reporting that torque wrenches used during production installation of bulkhead fittings on the oxygen lines of the flightcrew oxygen mask stowage boxes and adapter fitting on the oxygen pressure gauge were out of calibration, which resulted in a higher torque level setting than required by drawing. This over-torque could cause damage to the oxygen line fittings which, if not corrected, could cause oxygen leakage before being annunciated and result in lack of oxygen to the flightcrew when needed.
In the NPRM, the FAA proposed to require replacement of the affected oxygen line fittings, as specified in Transport Canada AD CF-2023-75. The FAA is issuing this AD to address the unsafe condition on these products.
You may examine the MCAI in the AD docket at regulations.gov under Docket No. FAA-2024-1009.
Discussion of Final Airworthiness Directive
Comments
The FAA received a comment from the Air Line Pilots Association, International (ALPA), who supported the NPRM without change.
Conclusion
This product has been approved by the aviation authority of another country and is approved for operation in the United States. Pursuant to the FAA's bilateral agreement with this State of Design Authority, it has notified the FAA of the unsafe condition described in the MCAI referenced above. The FAA reviewed the relevant data, considered the comment received, and determined that air safety requires adopting this AD as proposed. Accordingly, the FAA is issuing this AD to address the unsafe condition on this product. Except for minor editorial changes, this AD is adopted as proposed in the NPRM. None of the changes will increase the economic burden on any operator.
Related Material Under 1 CFR Part 51
Transport Canada AD CF-2023-75 specifies procedures for replacement of the bulkhead fittings on the oxygen lines of the mask stowage boxes and replacement of the fitting adapter on the oxygen pressure gauge. This material is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.
Costs of Compliance
The FAA estimates that this AD affects 24 airplanes of U.S. registry. The FAA estimates the following costs to comply with this AD:
| Labor cost | Parts cost | Cost per product | Cost on U.S. operators |
|---|---|---|---|
| 6 work-hours × $85 per hour = $510 | $350 | $860 | $20,640 |
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.
The FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: General requirements. Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
This AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
(1) Is not a "significant regulatory action" under Executive Order 12866,
(2) Will not affect intrastate aviation in Alaska, and
(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
The Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:
PART 39-AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority:
49 U.S.C. 106(g), 40113, 44701.
[top]
2. The FAA amends §?39.13 by adding the following new airworthiness directive:
2024-14-01 MHI RJ Aviation ULC (Type Certificate Previously Held by Bombardier, Inc.): Amendment 39-22782; Docket No. FAA-2024-1009; Project Identifier MCAI-2023-01221-T.
(a) Effective Date
This airworthiness directive (AD) is effective September 24, 2024.
(b) Affected ADs
None.
(c) Applicability
This AD applies to MHI RJ Aviation ULC (Type Certificate previously held by Bombardier, Inc.) Model CL-600-2D15 (Regional Jet Series 705) and CL-600-2D24 (Regional Jet Series 900) airplanes, certificated in any category, as identified in Transport Canada AD CF-2023-75, dated November 28, 2023 (Transport Canada AD CF-2023-75).
(d) Subject
Air Transport Association (ATA) of America Code 35, Oxygen.
(e) Unsafe Condition
This AD was prompted by a report that torque wrenches used during production installation of bulkhead fittings on the oxygen lines of the flightcrew oxygen mask stowage boxes and adapter fitting on the oxygen pressure gauge were out of calibration, which resulted in a higher torque level setting than required. The FAA is issuing this AD to address this over-torque, which could cause damage to the oxygen line fittings. The unsafe condition, if not addressed, could result in oxygen leakage before being annunciated and result in lack of oxygen to the flightcrew when needed.
(f) Compliance
Comply with this AD within the compliance times specified, unless already done.
(g) Requirements
Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, Transport Canada AD CF-2023-75.
(h) Exception to Transport Canada AD CF-2023-75
(1) Where Transport Canada AD CF-2023-75 refers to its effective date, this AD requires using the effective date of this AD.
(2) Where Transport Canada AD CF-2023-75 refers to hours air time, this AD requires using flight hours.
(i) Additional AD Provisions
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the manager of the International Validation Branch, mail it to the address identified in paragraph (j) of this AD. Information may be emailed to: 9-AVS-NYACO-COS@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, International Validation Branch, FAA; Transport Canada; or MHI RJ Aviation ULC's Transport Canada Design Approval Organization (DAO). If approved by the DAO, the approval must include the DAO-authorized signature.
(j) Additional Information
For more information about this AD, contact Fatin Saumik, Aviation Safety Engineer, FAA, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 516-228-7300; email Fatin.R.Saumik@faa.gov.
(k) Material Incorporated by Reference
(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the material listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.
(2) You must use this material as applicable to do the actions required by this AD, unless this AD specifies otherwise.
(i) Transport Canada AD CF-2023-75, dated November 28, 2023.
(ii) [Reserved]
(3) For Transport Canada AD CF-2023-75, contact Transport Canada, Transport Canada National Aircraft Certification, 159 Cleopatra Drive, Nepean, Ontario K1A 0N5, Canada; telephone 888-663-3639; email TC.AirworthinessDirectives-Consignesdenavigabilite.TC@tc.gc.ca. You may find this Transport Canada AD on the Transport Canada website at tc.canada.ca/en/aviation.
(4) You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195.
(5) You may view this material at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, visit www.archives.gov/federal-register/cfr/ibr-locations, or email fr.inspection@nara.gov.
Issued on July 10, 2024.
James D. Foltz,
Deputy Director, Compliance & Airworthiness Division, Aircraft Certification Service.
[FR Doc. 2024-18629 Filed 8-20-24; 8:45 am]
BILLING CODE 4910-13-P